Front Auger Bolt On Auger Stub Shafts
The previous Weld In Front Auger Stub Shafts & 11 tooth sprockets are no longer supplied
These have been superceded by a Bolt On Auger Stub Shaft Complete With Integral 11 tooth Sprockets
|
It is important on Early Easi Feeder Models (80-140 only) to measure the length of the 11 tooth sprocket from the back of the bolt- on flange to the front of the 11 tooth sprocket click here. This is because, on the early Easi-Feeder models, this measurement was only 95mm instead of the later 115mm. Therefore it is not compatible. A modified auger stub shaft has been produced to facilitate this P/N 703250
 |
P/N 703250
Back to Auger Part Number Main Page
| Home | Mixers | Orbitals | Customer Services | KFD World | Contact us |